Smart7 Notices - Novatel SMART7 Installation And Operation Manual

SMART7 Notices

SMART7 Notices
The following notices apply to the SMART7 device.
Changes or modifications to this equipment, not expressly approved by NovAtel Inc.,
could void the user's authority to operate this equipment.
FCC
This device complies with part 15 of the FCC Rules. Operation is subject to the following two con-
ditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
SMART7 has been tested and found to comply with the radiated and conducted emission limits
for a Class B digital device. The Class B limits are designed to provide reasonable protection
against harmful interference in a residential installation.
The equipment listed generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Re-orient or relocate the SMART7
l
Increase the separation between the equipment and the SMART7
l
Connect the equipment to an outlet on a circuit different from that to which the SMART7 is
l
connected
Consult the dealer or an experienced radio/TV technician for help
l
The SMART7 has been authorized for use in Mobile applications. At least 20 cm (8
inches) of separation between the SMART7 and the User must be maintained at all
times.
Wi-Fi
SMART7 contains a Wi-Fi radio with the following approvals:
FCC ID: UTU-01019715
l
Innovation, Science and Economic Development (ISED) Canada
SMART7 Class B digital device complies with Canadian ICES-003.
SMART7 appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
This device complies with ISED license-exempt RSS-GEN and RSS-247. Operation is subject to
the following two conditions: (1) this device may not cause interference and (2) this device must
accept any interference, including interference that may cause undesired operation of the
device.
Cet appareil est conforme à la norme ISED RSS-GEN et RSS-247. Son fonctionnement est sou-
mis aux deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2)
SMART7 Installation and Operation User Manual 0C 10