Table of Contents
Advertisement
5.After you fininshed sharpening all of the teeth set for your
current angle, turn off the machine by pushing the red button on
the Switch Plate(#5) and unplug the unit.
6.Loosen the Lock Wheel(#18)and reset the angle so that the
first tooth that hasn't been sharpened is positioned against the
Chain Stop (#23) and locked in as explained on page 6. See
FIGURE 11.
7.As you did with the first half of the chain, be sure to lower the
Top Housing(#4) so that the Grinding Wheel (#8) skims the
chain tooth, and lock it in place. See page6. Follow all of the
steps on page 6 double checking everything before you plug in
the machine and turn it on again.
Remember to turn off the machine and unplug it if you need to make any adjustments.
8.After you repeat all of the steps under sharpening on page7, your chain is ready to be mounted on your
saw.
1.Keep the Sharpener clean and free of dust, metal debris and dirt.
2.Check the grinding wheel before each use to make sure it isn't damaged. Do not use a grinding wheel if it is
chipped, cracked, or worn. You can check if the wheel has cracks not visible to the human eye by hanging it
up by the central hole and tapping it with a non metal object (ie: screwdriver handle). If it is in good condition it
will produce a metallic sound. A dull sound indicates a crack or break.
3.Replace the grinding wheel when it grinds down to a diameter of 3 inches.
Maintenance
Page 8
Get other manuals https://www.bkmanuals.com
Advertisement
Table of Contents
