Start And Stop By Instructions; Automatic Start By Setting - Panasonic FP0H User Manual

3.1.2 Start and Stop by Instructions

 Overview
• The logging/trace operation can be started and stopped by user programs for each
logging/trace number.
• Specify a logging/trace number (0 to 3) using the dedicated instruction, and execute with
arbitrary conditions.
R100
R9182
（ ）
DF
R101
R9180
（ ）
DF
• It takes a few milliseconds to a few seconds to start or stop the logging/trace operation.
• For stopping the logging/trace operation with instructions, request the stop after confirming
that the execution active flag (R9180/R9190/R9200/R9210) turns on. If requesting to stop
LOG n during the start operation, the operation error flag (R9007/R9008) or the logging/trace
error flag (R9185/R91915/R9205/R9215) turns on.
• For starting the logging/trace operation with instructions, request the start after confirming
that the logging/trace completed flag (R9182/R9192/R9202/R9212) turns on. If requesting to
stop LOG n during the start operation, the operation error flag (R9007/R9008) or the
logging/trace error flag (R9185/R9195/R9205/R9215) turns on.
• There is no problem if a start request is made for LOG n that is activated or during the
startup operation.
• There is no problem if a stop request is made for LOG n that is stopped or during the stop
operation.

3.1.3 Automatic Start by Setting

• When "Autostart" has been selected in the "LOG file settings" dialog box, the start request of
the logging/trace operation is made immediately after the mode is switched to RUN mode.
•
The trace operation stops when the trace stop condition (bit device ON or
buffer full) is met. If the operation is forcibly stopped with the tool software
or instruction while the trace stop condition has not been satisfied, the
trace operation is canceled and the data is not saved.
3.1 Start and Stop of Logging/Trace Operation
F420 LOGST K0
n
F421 LOGED K0
n
n：Log no.
n：Log no.
3-3