16. MECHANICAL ADJUSTMENT
16.4 Mechanical adjustment of the main drive unit section
16.4.1
PC drive gear positioning adjustment
This adjustment must be made in the following case:
• When the color PC drum motor was removed.
See P.166
• When the main drive unit was removed.
See P.116
A. Checking method
1. Slowly turn the PC drive gear/1 [1], and fit the hole A [3] and B [4] with the gear holes
on the upper frame [2].
2. Visually check if the hole A [3] and B [4] are fit with each gear hole at the same time.
B. Adjusting method
[2]
[1]
654
[3]
[2]
1. Turn the PC drive gear/1 [1], and fit
[4]
2. Fix the PC drive gear/1 [1], and then
[3]
A00JF2C454DA
Service Manual
Field Service Ver. 2.0 Jul. 2009
[1]
the hole A [2] with the PC Gear/1 [1]
hole while visually checking.
fit the hole B [3] with the PC drive
gear/2 [4] hole while visually check-
ing.
[4]
A00JF2C453DA
Y110571-1