Fs-Fn Adjustment - 1St Z-Fold Position Fs-Fn Adjustment - 2Nd Z-Fold Position - Olivetti d-Color MF651 Service Manual

Field Service Ver. 2.0 Jul. 2009
12.16.11 FS-FN adjustment - 1st Z-Fold Position
FS-FN adjustment - 2nd Z-Fold Position
A. Use
• To adjust the positions of the 1st Z-fold and 2nd Z-fold for the Z-fold mode.
• Make the adjustment upon setup of ZU-606.
<Procedure>
Position of the second fold
1. Make copies in the Z-fold mode.
2. Make an adjustment so that the width a is within the following range.
11 x 17
A3
B4
8.5 x 14
8K
Setting range: -12.8 mm to +12.7 mm (Step = 0.1 mm)
NOTE
• Length of the 1st fold is for standard value.
• The adjustable range for B4 size is only between -2.0 mm and +2.0 mm.
• 8.5 X 14 is available for only an half fold.
3. Call the Service Mode to the screen.
4. Touch [Finisher]
5. Select [ALL] and make the setting using [+] or [-].
To increase the length of the 1st fold (2nd fold), enter a negative value with [-] key.
To decrease the length of the 1st fold (2nd fold), enter a positive value with [+] key.
NOTE
• The adjustment setting value used for each paper size is the value set with [ALL]
plus the value set for each paper size.
6. Touch [OK] twice.
7. Touch [Exit] on the Service Mode screen.
8. Turn OFF the main power switch, wait for 10 sec., then turn the switch ON.
9. Make copies in the Z-fold mode and check for possible deviation from the specified 1st
and 2nd Z-fold positions.
Y110571-1
Length of the first fold
a
Length of the second fold
Length of 1st fold
108 mm
105 mm
91 mm
-
98 mm
[FS-FN adjustment]
Service Manual
Position of the first fold
L
Length a
4.0 ± 2.0 mm
4.0 ± 2.0 mm
4.0 ± 2.0 mm
-
4.0 ± 2.0 mm
[1st Z-Fold Position] or [2nd Z-Fold Position].
12. SERVICE MODE
A109F3C500DA
Length L
Less than 215 mm
Less than 209 mm
Less than 181 mm
Less than 241.7 mm
Less than 194 mm
605