Firmware Rewriting; Outline; Usb Memory; Preparation - Olivetti d-Color MF651 Service Manual

Field Service Ver. 2.0 Jul. 2009
7.

FIRMWARE REWRITING

7.1

Outline

• There are two ways to update the firmware: One is by directly connecting with the main
body using the USB memory device, and the other is by downloading over a network
using the Internet ISW.
NOTE
• When updating the firmware to the ver.4x, it is necessary to execute the following
steps to update the firmware.
1. Touch [BootRom] in the firmware update item display, and touch [START].
2. Check the message "BootRom Update completed successfully", and touch [OK].
3. Rewrite the firmware data.
4. Select [Service Mode]
new version.
See P.543
5. When operating the machine with the function version 2, select [Service Mode]
tem 2] [Software Switch Setting] and change the function version of the machine.
(When operating the machine as the function version 1 on the firmware ver.4x, this set-
ting is unnecessary.)
See P.533
6. Turn OFF and ON the main power switch and sub power switch.
7. Install the loadable device driver.
See P.631
8. Install the OCR dictionary data for the searchable PDF as occasion demands.
See P.543
7.2

USB memory

7.2.1

Preparation

• Conditions for USB memory which can be used for updating the firmware are as follows:
- Without security function added (security function can be turned off)
- Memory with 1 GB to 2 GB are recommended (One with 4 GB or more may not oper-
ate)
- Corresponds to USB2.0
- Formatted with FAT32 type
7.2.2

Procedure

1. Connect the USB to the PC, and copy the firmware data to the USB memory.
NOTE
• The firmware data to be updated must be copied to the root directory with the file
name "A0P0FW. tar."
• More than one firmware data with a single model or multiple models can be stored
in the USB memory. (Maximum of fifteen files)
When storing more than one firmware data, make a folder with a name "(model
code) FW" ("A0P0FW" for this machine) right under the root directory.
(File names can be set arbitrarily)
• When making a folder and storing more than one firmware data, it is also neces-
sary to copy the firmware data "A0P0FW. tar" to the root directly.
2. Turn OFF the main power switch and the sub power switch.
Y110571-1
[System 2] [Data Install], and update the movie data to the
Service Manual
7. FIRMWARE REWRITING
[Sys-
231