Auto Defogging System - Hyundai Santa Fe Owner's Manual

To defrost outside windscreen
[A] : Type A, [B] : Type B
1. Set fan speed to the highest posi-
tion.
2. Set temperature to the extreme
hot (HI) position.
3. Press the defroster button (
4. The air-conditioning will turn on
according to the detected ambient
temperature and outside (fresh)
air position will be selected auto-
matically.
If the position is selected, lower
fan speed is controlled to higher fan
speed.

Auto defogging system

(only for automatic climate
control system, if equipped)
Auto defogging reduces the possibili-
ty of fogging up the inside of the wind-
screen by automatically sensing the
moisture on inside the windscreen.
The auto defogging system operates
when the heater or air conditioning is
on.
i
Information
OTM048328
The auto defogging system may not
operate normally, when the outside
temperature is below -10 °C.
To cancel or set the Auto Defogging
System, keep the front defroster but-
ton pressed for 3 seconds. The "ADS
).
OFF" symbol will be shown in the cli-
mate display to inform you that the
system is deactivated. To re-activate
the auto defogging system, follow the
procedure mentioned above and the
"ADS OFF" symbol will disappear.
If the battery has been disconnected
or discharged, it resets to the auto
defogging status.
i
Information
For efficiency, do not select recirculat-
ed air position whilst the Auto defog-
ging system is operating.
NOTICE
Do not remove the sensor cover
located on the top of the wind-
screen glass.
Damage to system parts could
occur and may not be covered by
your vehicle warranty.
3
3-183