Quick Reference Table - Supermicro X11DSC+ User Manual

Super X11DSC+ User's Manual

Quick Reference Table

Jumper Description
JBT1 CMOS Clear
JPME2 Manufacturing Mode Select
JWD1 Watch Dog Timer Enable
Connector Description
COM1 Backpanel COM Port
FAN1-5 System Cooling Fan Headers
IPMI_LAN Dedicated IPMI_LAN Port
I-SATA0-3 SATA 3.0 Connection Header Supported by the Intel® PCH
I-SATA Ports with built-in power pins and with support of Supermicro SuperDOM (Disk On Module)
I-SATA2/I-SATA3
devices
I-SGPIO1 Serial Link General Purpose I/O Header
JBAT1 Onboard CMOS Battery Socket
JF1 Front Control Panel Header
JI2C_EXP1/2 System Management Bus (SMBus) I2C for SAS3 Backplanes
JI2C_FP1 System Management Bus (SMBus) I2C for LCD Devices
JIPMB1 4-pin BMC External I
JL1 Chassis Intrusion Header
(CPU1) JMEZZ1/JMEZZ2 PCI-Express 3.0 x8 Add-On-Module (AOM) slot from CPU1 for mezzanine card support (See the
PCI-E note below)
NVMe SMBus (I
JNVI C1/JNVI C2 proprietary NVMe add-on card and cable are required; available for a Supermicro complete system
2 2
only)
JPI C1 Power Supply SMBus I
2
JPWR2/JPWR3 8-pin Power Supply Connectors
JPWR1 24-pin ATX Main Power Supply Connector
JRK1 Intel® RAID Key Header for NVMe SSD
JSD1/JSD2 SATA DOM Power Connectors 1/2
JSDCARD1 Micro SSD (Solid State Drive) Card Slot (reserved for manufacture use only)
JSEN1 Inlet Sensor Header
JSTBY1 Standby Power Header
JTPM1 Trusted Platform Module (TPM)/Port 80 Connector
P1_NVMe0-3 NVM Express PCI-E 3.0 x4 ports (ports 0-3) supported by CPU1
Note 1: For SAS support, be sure to use an SMC-proprietary mezzanine card. Install
the mezzanine card (AOM-S3108M-H8L) with the LSI 3108 controller built-in on the
(CPU1) JMEZZ1 PCI-E slot for SAS 3.0 support. Refer to Section 1-9 and Section 2-5
for more information.
Note 2: To avoid causing interference with other components, please be sure to use
an add-on card that is fully compliant with the PCI-standard on a PCI slot.
C Header (for an IPMI-supported card)
2
C) headers used for PCI-E hot-plug SMBus clock & data connections (an SMCI-
2
C Header
2
12
Default Setting
Open (Normal)
Pins 1-2 (Normal)
Pins 1-2 (Enabled, Reset)