Motherboard Features - Supermicro X11DSC+ User Manual

Super X11DSC+ User's Manual

Motherboard Features

CPU
•
This motherboard supports dual Intel® Xeon® Scalable (Socket P) processors which offer three Intel
Interconnect (UPI) of up to 10.4 GT/s
Note: Both CPUs need to be installed for full access to the PCI-E slots, DIMM slots, and onboard controllers. Refer
to the block diagram on page 18 to determine which slots or devices may be affected.
Memory
•
Integrated memory controller embedded in the processor supports up to 3TB of 3DS Load Reduced DIMM (3DS LRDIMM),
3DS Registered DIMM (3DS RDIMM), Non-Volatile DIMM (NVDIMM) DDR4 (288-pin) ECC of up to 2666 MHz modules
in 24 slots
DIMM Size
•
Up to 128GB at 1.2V
Note 1: Memory speed and maximum memory support depend on the processors used in the system.
Note 2: For the latest CPU/memory updates, please refer to our website at
motherboard.
Chipset
•
Intel® C621 for X11DSC+
Expansion Slots
•
One (1) PCI-E 3.0 x16 SIOM networking slot supported by CPU1
•
One (1) PCI-E 3.0 x8+x8 SAS3 AOM slot for mezzanine card supported by CPU1
•
One (1) PCI-E 3.0 x8 slot supported by CPU2 (CPU2 Slot1)
•
Two (2) PCI-E 3.0 x16 slots supported by CPU2 (CPU2 Slot2/CPU2 Slot3)
BaseBoard Management Controller (BMC)
•
ASPEED AST2500 Baseboard Controller (BMC) supports IPMI 2.0
•
One (1) Dedicated IPMI LAN located on the I/O backpanel
Graphics
•
Graphics controller via AST2500 BMC (BaseBoard Management Controller)
Network Connection
•
One IPMI-dedicated LAN supported by the AST2500 BMC
I/O Devices
•
Serial (COM) Port
•
SATA 3.0
•
RAID (PCH)
Motherboard Features
•
One (1) Fast UART 16550 port on the I/O backpanel
•
Four (4) SATA 3.0 ports supported by Intel® PCH (I-SATA 0-3)
•
Two (2) of the four SATA 3.0 ports with power-pins built-in, w/support of
Supermicro SuperDOM (I-SATA2/I-SATA3)
•
RAID 0, 1, 5, and 10
14
UltraPath
®
http://www.supermicro.com/products/