Quick Reference Table - Supermicro X11SSi-LN4F User Manual

Quick Reference Table

Jumper Description
JBR1 BIOS Recovery
JBT1 Clear CMOS
JI 2 C1/JI 2 C2 SMB to PCI Slots (X11SSA-F only)
JPG1 VGA Enable
JPL1-JPL4 LAN1-LAN4 Enable (LAN3/LAN4: for X11SSi-LN4F only)
JPME1 ME Recovery
JPME2 Manufacturing Mode Select
JWD1 Watch Dog Enable
LED Description
LE5 BMC Heartbeat LED
LED1 Rear UID LED
LED4 Onboard Power LED
Connector Description
BT1 Onboard Battery
COM1/COM2 COM1/COM2 Port Headers
FAN1-FAN4, FANA System/CPU Fan Headers
IPMI_LAN Dedicated IPMI Gigabit (RJ45) Port
I-SATA2-I-SATA7 SATA 3.0 Connectors via Intel PCH (6Gb/s)
I-SGPIO 1/2 Serial Link General Purpose I/O (SGPIO) headers for I-SATA 3.0 connections (I-SGPIO1 for
I-SATA2-4, I-SGPIO2 for I-SATA5-7)
J25 M.2 Socket 3 (supports 2242, 2260, 2280, 22110 for NVMe and SATA SSD)
J28 Front Panel LED jumper for LAN3 and LAN4 (X11SSi-LN4F only)
JCFG1 (For internal debugging only)
JD1 Speaker/Power LED Indicator
JF1 Front Control Panel Header
JIPMB1 4-pin External BMC I
JL1 Chassis Intrusion Header
JPI 2 C1 Power I
JPWR1 24-pin ATX Main Power Connector (Required)
JPWR2 +12V 8-pin CPU Power Connector (Required)
JSD1/JSD2 SATA Disk On Module (DOM) Power Connectors
JSTBY1 Standby Power Header
JTPM1 Trusted Platform Module (TPM)/Port 80 Connector
UID (Unit Identification) Switch
JUIDB1
LAN1-LAN4 Gigabit (RJ45) LAN Ports (LAN3/LAN4: for X11SSi-LN4F only)
Note: Table is continued on the next page.
2 C Header (for an IPMI Card)
2 C System Management Bus (Power SMB) Header
13
Chapter 1: Introduction
Default Setting
Pins 1-2 (Normal)
See Chapter 2
Pins 2-3 (Disabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Normal)
Pins 1-2 (Normal)
Pins 1-2 (Reset)
Status
Green: Blinking; BMC Normal
Blue: On; Unit Identified
Green: Solid On; Power On