Table of Contents
Advertisement
Recommended
Adjustments
For your convenience, the adjustments listed
below have been performed at the factory.
However, because of the many variables involved
with shipping, we recommend that you at least
verify the following adjustments to ensure the best
possible results from your new machine.
Step-by-step instructions for these adjustments
can be found on the referenced page for each
item.
Factory adjustments that should be verified:
•
Riving knife alignment (Page 48)
•
Blade tilt calibration (Page 73)
•
Sliding table parallelism to blade (Page 74)
•
Crosscut fence 90° to blade (Page 76)
-42-
Model G0699 (Mfd. Since 5/15)
Advertisement
Table of Contents
