Grizzly G0699 Owner's Manual page 68

2.
Place the workpiece 1" in front of the blade
and evenly against the table and the auxiliary
fence.
Auxilliary Fence
Blade
Workpiece
Push Stick
for Side
Support
Blade Path
Figure 130. Push block in position to push
workpiece through blade.
3. Turn the saw ON, then begin ripping the
workpiece using a push stick for side sup-
port.
As the workpiece nears the end of the cut,
place the push block on the auxiliary fence
with the lip directly behind the workpiece,
then release the push stick just before it
is even with the blade (see the example in
Figure 131).
-66-
Release
Push Stick
Before Blade
Push
Figure 131. Example of ripping with push block.
Block
Turn the saw OFF and allow the blade to
come to a complete stop before removing
the cut-off piece. Failure to follow this warn-
ing could result in serious personal injury.
Lip
Blade Path
Model G0699 (Mfd. Since 5/15)
Push
Block