Table of Contents
Advertisement
56. Slide the crosscut fence against the 90° stop
bolt, then secure it in place by tightening the
M8-1.25 knob with the T-Nut block and 8mm
fender washer on the T-bolt (see Figure 47
on Page 33 and Figure 49 below). Tighten
M8-1.25 knob with 8mm fender washer onto
pivot stud.
Note: Adjusting the crosscut fence in different
positions will be discussed in the Operations
section later in this manual.
M8-1.25 Knob
w/8mm Fender
Washer
Figure 49. Crosscut fence secured.
57. Move the crosscut extension fence out so
that you can install the flip stop assemblies,
as shown in Figure 50.
Extension
Fence
Figure 50. Crosscut flip stops installed.
-34-
M8-1.25 Knob w/
T-Nut Block & 8mm
Fender Washer
Flip Stops
58. Thread (1) M12-1.75 x 70 arm-leveling bolt
with M12-1.75 jam nut into bracket con-
nected to rear of machine body, as shown in
Figure 51.
Arm-Leveling Bolt
M12-1.75 Jam Nut
Arm-
Support
Studs
Figure 51. Arm-support studs installed in body
and arm-leveling bolt installed in bracket.
59. Remove hex nuts from pre-installed arm-
support studs (see Figure 51), and install
support-arm base onto arm-support studs, as
shown in Figure 52.
Arm-Support Base
Arm-Support Studs
Figure 52. Installing arm-support base.
60. Adjust arm-leveling bolt until arm support
base is parallel with floor (see Figure 53 on
Page 35).
Tip: Check this position by using a tape to
measure the distance between each end of
the arm-support base and the floor.
Note: This parallel position helps ensure the
blade guard is parallel with the table once it is
installed. For now, this positioning should be
very close. It will be checked, and if neces-
sary, fine-tuned in a later step.
Model G0699 (Mfd. Since 5/15)
Bracket
Advertisement
Table of Contents
