Table of Contents
Advertisement
Adjusting Scoring Blade
The goal in this procedure is to adjust the scoring
blade vertical and horizontal positions so that the
scoring kerf is the same width as the main blade
kerf and is aligned with it. This will require placing
the straightedge on both sides of the blades mul-
tiple times as you make adjustments.
Tools Needed
Hex Wrench 8mm .............................................. 1
T-Handle Wrench 8mm ..................................... 1
Straightedge ...................................................... 1
To adjust the scoring blade position:
1.
DISCONNECT SAW FROM POWER!
2.
Adjust the blade tilt to 0° and raise the blade
all the way up.
3.
Raise blade guard up and move it away from
blade.
4.
Move the sliding table all the way forward to
expose the red blade cover, lock it in place,
then open the blade cover.
5.
When positioning the straightedge, place it
against teeth on both sides of the main saw
blade to obtain an accurate reading of the
main saw blade kerf.
— Horizontal Adjustment: Insert the T-handle
wrench into the right hole shown in Figure
95, engage it with the adjustment bolt
under the table, then rotate the wrench to
position the scoring blade.
Scoring Blade
Figure 95. Adjusting the horizontal position of
the scoring blade.
Model G0699 (Mfd. Since 5/15)
Qty
6.
Straightedge
— Vertical Adjustment: Insert the T-handle
wrench into the left hole shown in Figure
96, engage it with the adjustment bolt
under the table, then rotate the wrench to
position the scoring blade.
Figure 96. Adjusting the vertical height of the
scoring blade.
Close the blade cover, properly reposition
blade guard, and move the sliding table back
to the center.
-53-
Advertisement
Table of Contents
