Table of Contents
Advertisement
7.
WITHOUT resetting the STOP button, press
the main blade ON button. The machine
should not start.
—If the machine does not start, the STOP
button safety feature is working correctly.
—If the machine does start (with the STOP
button pushed in), turn the main blade
motor OFF and immediately disconnect the
power. The STOP button safety feature is
not working correctly. This safety feature
must work properly before proceeding with
regular operations. Call Tech Support for
help.
8.
Reset the STOP button.
9.
Verify that the power is not connected out-
of-phase by starting/stopping the main blade
and determining if the motor and blade turn
in the correct direction, using the criteria
below:
— If the main blade turns clockwise (when
standing in front of the machine), it is turn-
ing in the correct direction (see Figure 70).
— If the main blade turns counterclock-
wise, it is turning in the wrong direction.
Stop the machine, disconnect it from the
power source, then refer to Correcting
Phase Polarity on Page 15 to correct this
condition.
Correct
Viewed Facing Blade From Front
Not Correct
Figure 70. Correct and incorrect rotation
directions for the main blade.
Model G0699 (Mfd. Since 5/15)
10. Push the STOP button, move the sliding table
all the way to the left, then carefully open the
red blade cover, as shown in Figure 71. This
activates the blade cover safety switch to
prevent the saw from starting while the cover
is open.
Blade Cover
Figure 71. Blade cover open.
11. While staying safely away from the blade,
reset the STOP button, then attempt to start
the scoring blade.
—If the machine does not start, the blade
cover safety switch safety feature is work-
ing correctly.
—If the machine does start (with the blade
cover open), immediately turn the machine
OFF and disconnect the power. The blade
cover safety switch safety feature is not
working correctly. This safety feature must
work properly before proceeding with regu-
lar operations. Call Tech Support for help.
12. Push the STOP button, carefully close the
blade cover, then move the sliding table back
to the center of the machine.
Congratulations! You have completed the assem-
bly, setup, and test run of the saw. Continue
with the recommended adjustments in the next
section.
-41-
Advertisement
Table of Contents
