Grizzly G0699 Owner's Manual page 38

67. Attach connection plate assembly with return
spring to blade guard using (2) M6-1 lock
nuts (see Figure 57).
Blade
Guard
Assembly
Figure 57. Installing blade guard connection
plate assembly onto blade guard assembly.
68. Attach connection plate assembly to end of
upper support arm, using (3) M6-1 x 20 cap
screws, (3) 6mm lock washers, and (3) 6mm
flat washers (see Figure 58).
x 3
Connection Plate
Assembly
Figure 58. Connection plate assembly attached
to upper support arm.
-36-
Return Spring
Connection Plate
Assembly
69. Slide upper support arm until at least one
blade guard roller is centered over blade (see
Figure 59), then tighten hex bolt from Step
65 on Page 35 to secure upper support arm.
Blade Guard
Roller (1 of 2)
Blade
Figure 59. Blade guard rollers centered over
blade.
70. Ensure front and rear blade guard rollers are
parallel with blade (see Figure 59).
— If rollers are parallel with blade, proceed to
Step 62.
— If rollers are not parallel with blade, loosen
cap screws shown in Figure 60, adjust
arm-support pedestal until rollers are par-
allel with blade, then re-tighten cap screws
to secure. Check to make sure both blade
rollers are centered over blade, and if
necessary, loosen hex bolt from Step 65
on Page 35, slide upper support arm until
rollers are centered over blade, then re-
tighten hex bolt to secure.
Arm Support
Pedestal
Figure 60. Adjusting alignment of arm-support
pedestal.
Model G0699 (Mfd. Since 5/15)
Cap Screws
that Secure
Arm Support
Pedestal