Table of Contents
Advertisement
Cyclone Dust Collectors
G0440—2 HP, 1354 CFM @ 2.5" SP
G0441—3 HP, 1654 CFM @ 2.0" SP
G0443—1
⁄
HP, 1025 CFM @ 2.6" SP
1
2
Cyclone action separates the heavy dust particles
from the fine particles and drops them into the
steel drum. Any remaining fine dust travels past
the impeller and is then trapped by a cartridge fil-
ter made of spun-bond polyester that filters 99.9%
of particles from 0.2–2.0 microns in size. The car-
tridge filter is pleated to provide a large surface
area for efficient air movement and a clear plastic
bag collect the fine cake that shakes off the filter
for consistent dust collector performance. Casters
mounted to the steel drum also make disposal of
the larger chips and dust as easy as it gets.
Figure 114. Model G0440 Cyclone Dust
Collector.
order online at
-60-
www.grizzly.com
T23037—Scoring Blade Replacement
Figure 115. Model T23037 Scoring Blade.
G7581—Superbar™
G7582—Master Plate
The miter slot mounted Superbar™ will align, tune
and calibrate your table saw to within ±0.001 in
just minutes. Replace your table saw blade when
calibrating the double disk ground Master Plate
for a precision measurement, with no run out!
Figure 116. Superbar™ and Master Plate.
H8029—5 Piece Safety Kit
This kit has four essential jigs. Includes two push
blocks, push stick, featherboard and combination
saw and router gauge. Featherboard fits
miter slots.
Figure 117. H8029 5 Piece Safety Kit.
1-800-523-4777
or call
Model G0699 (Mfd. Since 5/15)
⁄
" x
⁄
"
3
3
8
4
Advertisement
Table of Contents
