Table of Contents
Advertisement
2.
Insert the provided T-handle wrench through
the table top hole shown in Figure 13 and
into one of the holes in the main blade pulley
under the table top. This will keep the blade
arbor from rotating during the next step.
3.
While holding the T-handle wrench with
one hand, rotate the arbor nut clockwise to
remove it and the flange (see Figure 14).
Arbor Nut
Figure 14. Main blade arbor nut and flange.
4.
Slide the saw blade over the arbor with the
teeth facing to the right, then re-install the
flange and arbor nut while holding the arbor
steady with the T-handle wrench, as shown in
Figure 15.
The beveled edge of the flange must be fac-
ing out and the arbor nut must be fully tight-
ened to safely secure the blade.
Figure 15. Installing main blade.
Model G0699 (Mfd. Since 5/15)
5.
Install and align riving knife (refer to Riving
Knife Alignment beginning on Page 48 for
detailed information).
6.
To make sure the scoring blade arbor nut is
fully tightened, hold the arbor wrench on the
arbor behind the blade and use the wrench
on the nut to tighten it clockwise, as shown in
Figure 16.
Flange
Figure 16. Tightening the scoring blade arbor
7.
Close the blade cover and lower the main
blade all the way down so that it does not
present a hazard during the following steps.
The sliding table is heavy, so you must get
help lifting it during the installation pro-
cess. We recommend two strong people lift
the sliding table and an additional person
help position the T-bolts into the mounting
holes as the table is lowered.
Arbor Wrench
nut.
NOTICE
-23-
Advertisement
Table of Contents
