Test Run - Grizzly G0699 Owner's Manual

12" sliding table saw w/scoring motor
Hide thumbs Also See for G0699:
Table of Contents

Advertisement

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The test run consists of verifying the following:
1) The motors power up and run correctly, 2) the
safety features of the Emergency Stop button and
blade cover switch work correctly, and 3) the main
blade turns forward (clockwise when viewed from
front of saw) and the scoring blade turns opposite
the main blade.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
To test run the machine:
1.
Make sure you understand the safety instruc-
tions at the beginning of the manual and that
the machine is set up properly.
2.
Make sure all tools and objects used during
setup are cleared away from the machine.
-40-
3.
Review the power controls shown in
Figure 68.
Main Blade
ON/OFF Buttons
Figure 68. Power controls.
4.
Push the STOP button in, then twist it clock-
wise so it pops out. When the STOP button
pops out, the switch is reset and ready for
operation (see Figure 69).
Figure 69. Resetting the STOP button.
5.
Verify that the machine is operating correctly
by pushing the main and scoring blade ON
buttons.
—When operating correctly, the machine
runs smoothly with little or no vibration or
rubbing noises.
— Investigate and correct strange or unusual
noises or vibrations before operating the
machine further. Always stop the machine
and disconnect it from power before inves-
tigating or correcting potential problems.
6.
Press the STOP button to stop the machine.
Model G0699 (Mfd. Since 5/15)
STOP Button
Scoring Blade
ON/OFF Buttons

Advertisement

Table of Contents
loading

Table of Contents