Table of Contents
Advertisement
— Vertical Adjustment: Insert the T-handle
wrench into the left hole shown in Figure 42,
engage it with the adjustment bolt under
the table, then rotate the wrench to position
the scoring blade.
Figure 42. Adjusting the vertical height of the
scoring blade.
48. Insert the M12-1.75 x 55 lock handle with a
12mm flat washer through the middle hole of
the crosscut table, as shown in Figure 43,
then loosely thread it into the T-nut plate.
Lock
Handle
Figure 43. Crosscut lock handle installed.
-32-
49. With the help of another person, place the
crosscut table on the swing arm pivot pin, as
shown in Figure 44, then slide the T-plate
into the sliding table T-slot.
T-Plate Into T-Slot
Figure 44. Installing the crosscut table into the
50. Position the crosscut table approximately in
the middle of the sliding table, then tighten
the lock handle to secure it in place.
51. Slide (2) M8-1.25 T-nuts into the crosscut
table brace, align the T-nuts with the holes
in the crosscut table, then secure the brace
T-Nut
with (2) M8-1.25 x 50 knobs and 8mm fender
Plate
washers, as shown in Figure 45.
Figure 45. Installing the crosscut table brace.
sliding table.
Crosscut
Table Brace
Model G0699 (Mfd. Since 5/15)
Advertisement
Table of Contents
