Troubleshooting For I/O Modules; Troubleshooting For Analog Modules (Ad/Da/Xa) And Temperature Modules (Rtd/Tc) - Delta AS Series Operation Manual

A S S e r i e s H a r d wa r e M a n u a l
The contents of the program
downloaded are incorrect.
8105
The program syntax is incorrect.
The contents of the program
downloaded are incorrect.
8106
The length of the execution code
_12
exceeds the limit.
The contents of the program
downloaded are incorrect.
8107
The length of the source code exceeds
the limit.
8000
Errors occur between software and
-
PLC.
8FFF

12.3 Troubleshooting for I/O Modules


Introduction to troubleshotting modules
Digital I/O, analog I/O, temperature measurement, load cell, and network modules can be installed in an AS Series
system. There are 2 types of error codes; error and warning. The CPU module and its modules stop operating when
errors occur. The CPU modules and its modules do not stop operating when warnings are triggered.
12.3.1 Troubleshooting for Analog Modules (AD/DA/XA) and
Temperature Modules (RTD/TC)
12.3.1.1
ERROR LED Indicators Are ON
You can set up HWCONFIG to have the following errors appear as warnings when they occur. Otherwise, when an error
occurs, only an error message appears.
Error
Code
16#1605 Hardware failure
16#1607 The external voltage is abnormal.
The factory calibration or the CJC is
16#1608
abnormal.
1 2 - 1 4
1. Download the program and parameters again.
2. Check the communication cable.
3. Save all the projects and compress the projects
into one compressed file and then hand this file
to the company or the technicians from the
agents.
1. Download the program and parameters again.
2. Save all the projects and compress the projects
into one compressed file and then hand this file
to the company or the technicians from the
agents.
1. Download the program and parameters again.
2. Save all the projects and compress the projects
into one compressed file and then hand this file
to the company or the technicians from the
agents.
1. Check if the product firmware and the software
used are the most updated versions.
2. Make a note of the operation procedures and
screenshots of the error windows and hand this
note to the company or the technicians from the
agents.
Description Solution
Contact the factory.
Check the power supply.
Contact the factory.
- H
- H
- H