Fitting The Mounting Plate To A Mast - Siemens HiPath V6R1 Installation Manual

9034532, October 2009
HiPath Wireless Outdoor AP Installation Guide
Mounting the HiPath Wireless Outdoor AP with mounting plate

3.5.5 Fitting the mounting plate to a mast

To fit the mounting plate to a mast:
1. Feed the fastening straps through the openings in the mounting plate
(position A in Figure
Figure 14 Mounting plate with fittings for mast mounting
2. Place the fastening straps around the mast at the required position.
3. Feed the free end of the strap through the quick-release fastener. You can
twist the tensioning screw (Position B in
fastening strap to the diameter of the mast.
4. Press the tensioning screw against the fastening strap and tighten the
tensioning screw, tightening torque 4.5 Nm.
Mounting the HiPath Wireless Outdoor APs
14).
Figure
OutdoorAP_Description.fm
14) to the side to adapt a
23