Table of Contents
Advertisement
Caution
Only use the loop (Position B in
Outdoor AP. This prevents the connector skewing on the back of the power supply adapter and breaking off.
9034532, October 2009
HiPath Wireless Outdoor AP Installation Guide
Connecting cables to the HiPath Wireless Outdoor AP
To fit and connect a power supply adapter:
1. Fit the power supply adapter in the HiPath Wireless Outdoor AP, as depicted
in
Figure
21. The connector on the rear of the power supply adapter must
engage fully in the socket of the housing. The entire rear surface of the power
supply adapter must make contact with the inner surface of the HiPath
Wireless Outdoor AP.
Figure 21
Using a power supply adapter in a HiPath Wireless Outdoor AP
Figure
21) to remove the power supply adapter from the HiPath Wireless
2. Connect the power supply adapter and the HiPath Wireless Outdoor AP with
the screw supplied with the power supply adapter (position A in
3. Connect the cable for the power supply. The assignment of the contacts is
depicted in
Figure
21.
4. Secure the power supply cable with a strain relief clamp.
OutdoorAP_ConnectingUp.fm
Fitting a power supply adapter
Figure
21).
35
Advertisement
Table of Contents
