Siemens HiPath V6R1 Installation Manual page 32

OutdoorAP_ConnectingUp.fm
Connecting cables to the HiPath Wireless Outdoor AP
Connecting the cables
32
You have the following options:
• Connect cables pre-assembled with a connector (Ethernet, antennas) by
inserting the connector into the appropriate socket. Secure antenna
cables by tightening the sleeve nut of the connector (key size SW8). For
more information, see
HiPath Wireless Outdoor AP", on page 36
an external antenna cable to the HiPath Wireless Outdoor AP", on page
37.
• 48 V DC power supply. Use the connector supplied with the HiPath
Wireless Outdoor AP.
• 110 - 230 V AC power supply. You will require a power supply adapter to
use this power supply.
2. Fit a strain relief clamp to the connected cable. The toothed part of the clamp
must enclose the cable completely (is depicted by Position B
3. Press the strain relief clamp into the housing until the cable is located
completely in the opening in the housing seal (Position C in
4. Seal all openings not required for cables with sealing plugs (Position D in
Figure 17).
5. Fit these sealing plugs in a strain relief clamp. The lower surrounding notch
must be enclosed by the toothing of the strain relief clamp (is depicted in
Figure 18). Press the strain relief clamp into the housing until the sealing plug
is located completely in the opening of the housing seal.
Figure 18 Securing a sealing plug with a strain relief clamp
Note: Keep unused sealing plugs and strain relief clamps for later use.
Section 4.5, "Connecting an Ethernet cable to the
and
HiPath Wireless Outdoor AP Installation Guide
Section 4.6, "Connecting
Figure 17).
Figure 17).
9034532, October 2009