5.4.5
Fitting the mounting plate to a mast
Procedure
Figure 5-12
Follow the steps below to fit the mounting plate to a mast:
1. Feed the fastening straps through the openings in the mounting plate (position A in the
2. Place the fastening straps around the mast at the required position.
3. Feed the free end of the strap through the quick-release fastener. You can twist the
4. Press the tensioning screw against the fastening strap and tighten the tensioning screw,
SCALANCE W786 outdoor access point
Operating Instructions, 06/2013, A5E02280428-08
Mounting plate with fittings for mast mounting
figure above).
tensioning screw (position B in the figure above) to the side to adapt a fastening strap to
the diameter of the mast.
tightening torque 4.5 Nm.
5.4 Mounting with mounting plate
Mounting
31