Screwing The Cover Plate To The Mounting Plate For The Cable Feedthrough - Siemens HiPath V6R1 Installation Manual

Warning
If the cable feedthrough on the rear of the device is exposed to spray water, degree of protection
IP65 no longer applies. In this case, water can penetrate the device and establish a live
connection to the line voltage. There is then a risk of electric shock. Ensure that you use the cover
plate for the cable feedthrough if you are not mounting the HiPath Wireless Outdoor AP on a wall.
9034532, October 2009
HiPath Wireless Outdoor AP Installation Guide
Mounting the HiPath Wireless Outdoor AP with mounting plate
Figure 10 Fitting the mounting plate to a wall
3.5.2 Screwing the cover plate to the mounting plate
for the cable feedthrough
The cabling of the HiPath Wireless Outdoor AP is led out of the rear of the device.
The housing seal is effective only when it is not subjected to spray water. If the
device is mounted on a wall, no further measures are necessary. When mounted
in any other way, an additional cover plate must be screwed to the mounting plate.
OutdoorAP_Description.fm
Mounting the HiPath Wireless Outdoor APs
19