OutdoorAP_Description.fm
Mounting the HiPath Wireless Outdoor APs
Fitting the housing cover
3.2 Fitting the housing cover
3.3 Attaching cables
14
To remove the housing cover:
1. Remove the sealing caps from the housing cover (Position A in
2. Loosen the screws in the cover (Position B in
Note: These screws remain in the cover after they have been loosened (this
design element prevents them from being lost). Never attempt to remove
these screws from the housing cover using force, otherwise the housing
cover will be damaged.
3. Remove the housing cover with the captive screws (Position C in
Fitting the housing cover is carried out in the reverse order of the sequential steps
of removing the housing cover. The tightening torque for the cover screws is 1.8
Nm.
3.3.1 Attaching cables prior to mounting
Before you screw the HiPath Wireless Outdoor AP to a wall or to the optional
mounting plate, you must connect the power supply cables, Ethernet cable, or
external antenna cables to the HiPath Wireless Outdoor AP.
Figure 5
Side view of HiPath Wireless Outdoor AP with cables entering from
different directions
Figure
HiPath Wireless Outdoor AP Installation Guide
Figure
4)
4).
Figure
4).
9034532, October 2009