Table of Contents
Advertisement
6.3 Industry Canada
9034532, October 2009
HiPath Wireless Outdoor AP Installation Guide
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Note: This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20 cm between the radiator and your body.
This device has been designed to operate with the antennas listed in
"Optional third-party external antennas", on page
of 18 dBi. Antennas not included in this list or having a gain greater than 18 dBi
are strictly prohibited for use with this device. The required antenna impedance
is 50 ohms.
This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
Professional Installation Notice:
To comply with FCC part 15 rules in the United States, the system must be
professionally installed to ensure compliance with the Part 15 certification. It
is the responsibility of the operator and professional installer to ensure that
only certified systems are deployed in the United States. The use of the
system in any other combination (such as co-located antennas transmitting
the same information) is expressly forbidden.
"Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
"This device has been designed to operate with the antennas listed in
"Optional third-party external antennas", on page
of 18 dBi. Antennas not included in this list or having a gain greater than 18 dBi
are strictly prohibited for use with this device. The required antenna impedance
is 50 ohms.
"To reduce potential radio interference to other users, the antenna type and its
gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.)
is not more than that permitted for successful communication.
"That the device for the band 5150-5250 MHz is only for indoor usage to reduce
potential for harmful interference to co-channel mobile satellite systems.
OutdoorAP_Certification.fm
Certification
Industry Canada
Section 5.2,
40, and having a maximum gain
Section 5.2,
40, and having a maximum gain
49
Advertisement
Table of Contents
