Table of Contents
Advertisement
3.9
Rotate transmitter housing
You can rotate the transmitter for better viewing, access, or antenna position. Loosen set screw
(see A in
Figure
to 180 degrees in either direction to desired position.
CAUTION
Tighten set screw.
3.10 Rotate display
If the transmitter's mounting is such that the display is not horizontal, you can rotate the display
90 degree clockwise or counterclockwise to provide horizontal viewing.
Tools required
#1 Phillips Screwdriver or 1/8" Slotted Screwdriver
Torque Screwdriver
1.5 mm hex key
Procedure
WARNING
Risk of death or serious injury by explosion. Do not open transmitter
enclosure when an explosive gas atmosphere is present.
Revision 2
3-14) on outside neck of transmitter one full turn. Rotate transmitter housing up
Do not rotate the housing past 180 degrees in any direction or you
could damage the internal wiring.
CAUTION:
Do not rotate
more than 180
Figure 3-14: Rotating transmitter housing
SmartLine Wireles User's Manual
A
0
3. Installation
3.9. Rotate transmitter housing
27
Advertisement
Table of Contents
