Table of Contents
Advertisement
4.4
Display sequence
After power up, the transmitter will display its boot sequence which includes the firmware
revision. It will then perform a sensor (meter body) check and proceed to connecting to the
wireless network. A series of messages will be displayed depending on the network connection
status. The process variable will also be displayed. Once connected to the wireless network, an
antenna symbol (triangle) will be shown on the left hand side of the LCD along with the process
variable on the right.
4.5
Provisioning
Before the transmitter can be configured it must be provisioned with a security key so it can join
the wireless network. Use the Provisioning Device Pocket PC software to receive security keys
from the Key Server manager, then aim the Pocket PC at the transmitter and transmit a key.
Transmitters in the OneWireless Network with R240 or later release software, can be provisioned
using over-the-air provisioning.
The Wireless Device Manager (WDM) provisions the access points, and the access points that
are enabled to function as provisioning devices can then provision the transmitters. To enable
the over-the-air provisioning capability, you must first enable this feature in the OneWireless
User Interface.
For more information, please reference the One Wireless R310 Wireless Device Manager User's
Guide (OWDOC-X254-en-310).
Revision 2
SmartLine Wireles User's Manual
4. Start up
4.4. Display sequence
45
Advertisement
Table of Contents
