Trane CVHH Installation, Operation And Maintenance Manual page 4

Introduction
Trademarks
All tradem arks referenced in this docum ent are the
tradem arks of their respective ow ners.
Revision History
CVHH-SVX001A-EN (10 Oct 2014)
• First version of this literature
4
Factory Warranty Information
Com pliance w ith the follow ing is required to preserve the
factory warranty:
All Unit Installations
Startup M UST be perform ed by Trane, or an authorized
agent of Trane, to VALIDATE this WARRANTY. Contractor
m ust provide a tw o-w eek startup notification to Trane (or
an agent of Trane specifically authorized to perform
startup).
Additional Requirements for Units Requiring
Disassembly
When a new fully assem bled chiller is shipped and
received from our Trane m anufacturing location and, for
any reason, it requires disassem bly or partial
disassem bly—w hich could include but is not lim ited to the
evaporator, condenser, control panel, com pressor/m otor,
purge, factory-m ounted starter or any other com ponents
originally attached to the fully assem bled unit—
com pliance w ith the follow ing is required to preserve the
factory warranty:
• Trane, or an agent of Trane specifically authorized to
perform start-up and warranty of Trane
perform or have direct on-site technical supervision of
the disassem bly and reassem bly w ork.
• The installing contractor m ust notify Trane—or an
agent of Trane specifically authorized to perform
startup and warranty of Trane
in advance of the scheduled disassem bly w ork to
coordinate the disassem bly and reassem bly w ork.
• Start-up m ust be perform ed by Trane or an agent of
Trane specifically authorized to perform startup and
®
warranty of Trane products.
Trane, or an agent of Trane specifically authorized to
perform start-up and warranty of Trane
provide qualified personnel and standard hand tools to
perform the disassem bly w ork at a location specified by
the contractor. Trane, or an agent of Trane specifically
authorized to perform start-up and warranty of Trane
products, w ill perform or have direct on-site supervision of
the disassem bly and reassem bly w ork. The contractor
shall provide the rigging equipm ent such as chain falls,
gantries, cranes, forklifts, etc. necessary for the
disassem bly and reassem bly w ork and the required
qualified personnel to operate the necessary rigging
equipm ent.
Im port ant : Any deviation from these requirem ents
m ust be agreed upon prior to startup in a
w ritten agreem ent from Trane.
®
products, w ill
®
products—tw o w eeks
®
products, w ill
CVHH-SVX001A-EN