Extron electronics IN1606 User Manual page 59

Connect
This option connects a device tab in emulation mode to a
device. The page goes from emulation mode to live mode.
Current device settings are displayed. The tab indicator
changes from gray (not connected) to green (connected).
NOTE: If a device is already connected, the
option is disabled until the device is disconnected or
the connection times out.
1. From the
Connections
Connection Settings window opens (shown at right).
2. Select the connection method from the list of radio
buttons.
Select the
• TCP/IP
through a LAN or WAN.
Enter the device IP address or hostname in the
password-protected, enter the password in the
Select the
• RS-232
through an RS-232 connection.
Select the desired values from the
NOTE: The default baud rate is 9600 baud.
Select the radio button if the device is connected to the host device through
• USB
the front panel mini-USB connector. Select the device from the list of devices.
3.
Click the button to connect to the device.
OK
Disconnect
This option disconnects the PCS program from the connected device and returns it to
emulation mode.
From the menu, select
Connections
NOTE: If a device is already disconnected, the
device is connected.
Exit
This option disconnects the scaler from the software and closes the application.
From the menu, select
Connections
IN1606 and IN1608 Series Scaling Presentation Switcher • Configuration Software
Connect
menu, select . The
Connect
radio button if the device is connected to the host device
radio button if the device is connected to the host device
and
COM Port
. The scaler tab enters Emulation mode.
Disconnect
Disconnect
. The application closes.
Exit
field. If the device is
IP Address
field.
Password
drop-down menus.
Baud Rate
option is disabled until the
53