Provisioning A Global Multisegment Pseudowire Description - Cisco ASR 9000 Series Configuration Manuallines

Implementing Point to Point Layer 2 Services
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p-pw)# pw-class dynamic_mpls
Enters pseudowire class submode, allowing you to define a pseudowire class template.
Step 7
exit
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p-pw)# exit
Exits pseudowire class submode and returns the router to the parent configuration mode.
Step 8 neighbor A.B.C.D pw-id value
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor 10.165.202.158 pw-id 300
Configures a pseudowire for a cross-connect.
The IP address is that of the corresponding PE node.
The pw-id must match the pw-id of the PE node.
Step 9 pw-class class-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p-pw)# pw-class dynamic_mpls
Enters pseudowire class submode, allowing you to define a pseudowire class template.
Step 10
commit
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p-pw)# commit
Saves configuration changes to the running configuration file and remains in the configuration session.

Provisioning a Global Multisegment Pseudowire Description

S-PE nodes must have a description in the Pseudowire Switching Point Type-Length-Value (TLV). The TLV
records all the switching points the pseudowire traverses, creating a helpful history for troubleshooting.
Each multisegment pseudowire can have its own description. For instructions, see the
Cross-Connect
SUMMARY STEPS
1. configure
2. l2vpn
Description". If it does not have one, this global description is used.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
Provisioning a Global Multisegment Pseudowire Description
"Provisioning a
113