Configuring Pwhe Crossconnect - Cisco ASR 9000 Series Configuration Manuallines

Implementing Multipoint Layer 2 Services
(interface pw-iw id) Configures the PWHE pseudowire interworking interface and enters the interface configuration
mode.
Step 3 attach generic-interface-list interface_list_name
Example:
RP/0/RSP0/CPU0:router(config-if)# attach generic-interface-list interfacelist1
Attaches the generic interface list to the PW-Ether or PW-IW interface . To remove the generic interface list from the
PW-Ether or PW-IW interface, use the no form of the command, that is, no generic-interface-list list-name
Step 4
Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.

Configuring PWHE Crossconnect

Perform this task to configure PWHE crossconnects.
SUMMARY STEPS
1. configure
2. l2vpn
3. xconnect group group-name
4. p2p xconnect-name
5. interface pw-ether id or interface pw-iw id
6. neighbor ip-address pw-id value
7. pw-class class-name
8. (Only PW-IW) interworking ipv4
9. Use the commit or end command.
DETAILED STEPS
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2
l2vpn
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
Configuring PWHE Crossconnect
295