Configuring Any Transport Over Mpls: Example - Cisco ASR 9000 Series Configuration Manuallines

L2vpn and ethernet services configuration guide
Hide thumbs Also See for ASR 9000 Series:
Table of Contents

Advertisement

Configuring Any Transport over MPLS: Example

PW: neighbor 90.90.90.90, PW ID 300, state is up ( established )
Configuring Any Transport over MPLS: Example
This example shows you how to configure Any Transport over MPLS (AToM):
config
l2vpn
xconnect group test
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
190
PW type
Ethernet VLAN
VCCV CV type 0x2
(LSP ping verification)
VCCV CC type 0x5
(control word)
(TTL expiry)
------------ ------------------------------ -----------------------------
Incoming Status (PW Status TLV):
Status code: 0x0 (Up) in Notification message
Outgoing PW Switching TLVs (Label Mapping message):
Local IP Address: 80.80.80.80, Remote IP address: 90.90.90.90, PW ID: 300
Description: S-PE1 MS-PW between 70.70.70.70 and 90.90.90.90
Outgoing Status (PW Status TLV):
Status code: 0x0 (Up) in Notification message
Statistics:
packet totals: receive 0
byte totals: receive 0
Create time: 04/04/2008 23:18:24 (00:01:24 ago)
Last time status changed: 04/04/2008 23:19:30 (00:00:18 ago)
PW class not set
Encapsulation MPLS, protocol LDP
PW type Ethernet VLAN, control word enabled, interworking none
PW backup disable delay 0 sec
Sequencing not set
PW Status TLV in use
MPLS
Local
------------ ------------------------------ -----------------------------
Label
16004
Group ID
0x2000800
Interface
GigabitEthernet0/1/0/0.3
MTU
1500
Control word enabled
PW type
Ethernet VLAN
VCCV CV type 0x2
(LSP ping verification)
VCCV CC type 0x5
(control word)
(TTL expiry)
------------ ------------------------------ -----------------------------
Incoming Status (PW Status TLV):
Status code: 0x0 (Up) in Notification message
Outgoing PW Switching TLVs (Label Mapping message):
Local IP Address: 80.80.80.80, Remote IP address: 70.70.70.70, PW ID: 100
Description: S-PE1 MS-PW between 70.70.70.70 and 90.90.90.90
Outgoing Status (PW Status TLV):
Status code: 0x0 (Up) in Notification message
Statistics:
packet totals: receive 0
byte totals: receive 0
Create time: 04/04/2008 23:18:24 (00:01:24 ago)
Last time status changed: 04/04/2008 23:19:30 (00:00:18 ago)
Implementing Point to Point Layer 2 Services
Ethernet VLAN
0x2
(LSP ping verification)
0x7
(control word)
(router alert label)
(TTL expiry)
Remote
16006
0x2000200
GigabitEthernet0/1/0/2.2
1500
enabled
Ethernet VLAN
0x2
(LSP ping verification)
0x7
(control word)
(router alert label)
(TTL expiry)

Advertisement

Table of Contents
loading

Table of Contents