Cisco ASR 9000 Series Configuration Manuallines page 409

Implementing IEEE 802.1ah Provider Backbone Bridge
4.
5.
6.
7.
8.
9.
10.
11.
12. Use the commit or end command.
DETAILED STEPS
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2
l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3 bridge group bridge-group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group pbb
Enters bridge group configuration mode. This command creates a new bridge group or modifies the existing bridge
group if it already exists. A bridge group organizes bridge domains.
Step 4
bridge-domain domain-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain pbb-edge
Enters bridge domain configuration mode. This command creates a new bridge domain or modifies the existing bridge
domain if it already exists.
Step 5
mac withdraw state-down
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# mac withdraw state-down
(Optional) Enables MAC withdrawal.
Step 6
exit
bridge-domain domain-name
mac withdraw state-down
exit
interface type interface-path-id.subinterface
interface type interface-path-id.subinterface
neighbor { A.B.C.D } pw-id value
exit
pbb edge i-sid service-id core-bridge core-bridge-name
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
Configuring Access Pseudowire in I-Component
383