Configuring Atom Ip Interworking - Cisco ASR 9000 Series Configuration Manuallines

Implementing Point to Point Layer 2 Services
• Entering cancel leaves the router in the current configuration session without exiting or committing the
configuration changes.
• Use the commit command to save the configuration changes to the running configuration file and remain within the
configuration session.
Step 8 show pim [ipv4] group-map [ip-address-name] [info-source]
Example:
RP/0//CPU0:router# show pim ipv4 group-map
(Optional) Displays group-to-PIM mode mapping.
Step 9 show pim [vrf vrf-name] [ipv4] topology [source-ip-address [group-ip-address] | entry-flag flag
| interface-flag | summary] [route-count]
Example:
RP/0/RSP0/CPU0:router# show pim topology
(Optional) Displays PIM topology table information for a specific group or all groups.

Configuring AToM IP Interworking

Perform this task to configure AToM IP Interworking.
SUMMARY STEPS
1. configure
2. l2vpn
3. xconnect groupgroup-name
4. p2pxconnect-name
5. interworking ipv4
6. Use the commit or end command.
DETAILED STEPS
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3
xconnect groupgroup-name
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
Configuring AToM IP Interworking
133