Replacing The Column Compartment's Firmware - Agilent Technologies 1100 Series Reference Manual

4
Repairing the Column Compartment

Replacing the Column Compartment's Firmware

The installation of new firmware is required
• if new version solves problems of currently installed version.
• if after exchange of the processor board (CCM) the version on board is older
To upgrade the column compartment's firmware the following steps have to be
performed:
1 Load the firmware into the column compartment, see the help system of
2 Perform a
3 If the CCM board was exchanged, re-enter the serial number information of
100
than previous installed one.
your user interface.
"Temperature Calibration Procedure"
recalibration parameters into the board's memory (only necessary if a
temperature calibration was done before).
the column compartment through the user interface, see
Serial Number using the Control Module"
Number using the ChemStation"
on page 46 to add the
on page 76 or
on page 76.
1100 Series TCC Reference Manual
"Entering the
"Entering the Serial