Dents On Paper At 48Mm Cycle In Fd - Konica Minolta AccurioPress C2070 Troubleshooting Manual

2.1.7. Dents on paper at 48mm cycle in FD

(1) Symptom
On the print, dent is seen every 48mm cycle in sub-scan direction (FD).
(2) Cause
The toner accumulated on the fusing separation claws drops and attaches to the fusing
paper exit roller. It is pressed to the paper and appears as dents on the paper.
(3) Solution
1. Clean the fusing paper exit roller.
Pull out the ADU mount and open the reverse section. Clean the roller indicated in
the below figure with the cleaning pad and the drum cleaner.
Rotate to arrowed direction
little by little and clean the
surface to remove the foreign
material.
KONICA MINOLTA Confidential
- 125 -