Loading Paper In Post Inserter Of Folding Unit Fd-503 - Konica Minolta bizhub PRO C1060L Quick Manual

G
Load the remaining paper into the tray, then press
the rear guide plate against the paper.
NOTICE
Be careful not to load paper above the , mark that indicates the
height limit on the side guide plate. Otherwise, a paper jam may
occur.
To load paper with the paper width less than 182 mm / 7.165", use
the small size guides built in the side guide plates. For information
about how to use the small size guides, refer to the HTML User's
Guide.
Be sure that the rear guide plate is securely pressed against the
paper. If there is any gap between the rear guide plate and the
paper, this machine will not be able to detect the correct paper size.
It may cause a paper feeder machine trouble.
Load paper with the print side facing up.
H
Close the tray.
Push the tray in until it locks into place.
The amount indicator changes from
[MACHINE] or [COPY] screen.
NOTICE
Carefully close the tray. Otherwise, the machine may be subjected to an unexpected impact due to the tray or
paper weight, which may lead to a machine error.

Loading Paper in Post Inserter of Folding Unit FD-503

Select [Paper Setting] on the [MACHINE] screen or the [COPY] screen, then change the paper setting of the upper tray
or lower tray of the post inserter.
A
Load paper into the upper tray or lower tray of the
post inserter.
The Amount indicator changes from
[MACHINE] screen or the [COPY] screen.
B
Press the tray guide plates against the paper.
NOTICE
Do not load more than 500 sheets (80 g/m
above the limit line indicated on the tray guide plates.
bizhub PRESS C1070/C1070P/C1060/C71hc
to in the tray information display area of the
to on the
2
/ 21 lb Bond) for each of the upper and lower trays. Also, do not load
bizhub PRO C1060L
4-4
4