E3L030 Control Module Vds (Vds Module) - Siemens Cerberus CS1140 Manual

E3L030 Control module VdS (VdS module)

32 E3L030 Control module VdS (VdS module)
32.1 Overview
32.2 Application
32.3 Key data
132
Building Technologies
Fire Safety & Security Products
I-Bus module for the connection of VdS peripheral equipment:
FBF Feuerwehr-Bedienfeld: Fire department control panel
ÜE Übertragungseinrichtung: Transmission device
FSD Feuerwehrschlüsseldepot: Fire department key cabinet
SST Standardschnittstelle (VdS) für fremde Lösch-Steuereinrichtung:
Standard interface (VdS) for 3rd party extinguishing activating device
TK Türkontakt Zentrale: Door switch control unit (door open = ÜE disabled)
Connection line to ÜE, FSD and SST monitored
All inputs/outputs to the peripheral equipment with EMI and over voltage protec-
tion
Emergency operation capability
Card format 233 mm x 200 mm
I-Bus address is set at programming switch "S3"
The VdS module is required for connection of the above mentioned peripheral
equipment.
It is possible to use several VdS modules or one single VdS module for all CPUs
within a C-Bus system.
Restriction: If one single VdS module is used for all CPUs, it must not be placed
in a CI1145–station. Activation in emergency operation mode would not be pos-
sible.
Several VdS modules per CPU would be possible if separate transmission paths
are required for different detector types (automatic/manual).
The VdS module is not FM compliant. It may be used in a ground fault moni-
tored installation, but it is not monitored itself. (For details –> see chapter 6)
All inputs/outputs are fix allocated (exception LED4)
Line resistance for FBF
Line resistance for FSD
Line resistance for ÜE
Line resistance for SST
Control output load
Quiescent current at 24 V
* Detail –> see page 135
max. 5 Ω or 20 Ω per wire *
max. 5 Ω or 50 Ω per wire *
max. 10 Ω per wire *
max. 10 Ω per wire *
max. 40 mA with EMI protection
18 mA (Normal operating mode)
001260_k_en_--.doc
02.2005