Table of Contents
Advertisement
Controls
7
Control panel
.07
The control panel is used to create and alter seam programs, enter parameter values and read
error messages and service settings.
The control panel consists of display 1 and the function keys described below. The display 1
consists of a two-line alpha-numerical LCD display with 16 symbols per line. The special
symbols 2, 3, and texts 4 show the respective status of the function keys and the operating
status of the machine.
The control panels switches on all LCD-segments and the horn automatically for a short time
during the power-on phase, after which the lettering PFAFF appears on the display, until the
higher ranking control unit sends commands to the control panel.
7
Screen displays
.07.01
7
Function keys
.07.02
The function keys described below are used basically to switch machine functions on and off.
If a corresponding value has to be set for the activated function, this is carried out with the
corresponding +/- key. For example, by pressing and holding the +/- key 5, the numerical
value 6 shown above the key is changed slowly to begin with. If the +/- key 5 is held down
longer, the numerical value 6 is changed more quickly.
7 - 4
4
SPEED
1
Activated functions are displayed with a triangular marking 2 below or next to the
respective function key.
In the sewing mode all relevant sewing data is displayed and these can be changed
directly, depending on the status of the machine, see also Chapter 10 Sewing.
During the parameter input the selected parameter number with the corresponding value is
displayed, see Chapter 13.12 Parameter settings.
During the seam program input the inputs are carried out in relevant input menus, see
Chapter 11.01 Seam program input.
2
3
6
2.0
5
Advertisement
Table of Contents
