13
Adjusting the zigzag sensor
.08
Requirement
At the right point of penetration of the needle (needle position 1), solenoid 3 should be
positioned exactly on switch surface 4, when the main drive of the machine is at position
"15".
Fig. 13 - 38
Switch on the machine.
Select parameter '702', see Chapter 13.12 Parameter settings.
Turn the balance wheel until the needle is at its right point of penetration and parameter
'702' has the value "15".
Turn the mounting plate 1 (screw 2) in accordance with the requirement.
Switch off the machine.
1
2
Adjustment
3
4
13 - 42