Table of Contents
Advertisement
FKT
Explanation
SM2
Move stepping motor SM2 (feed regulator)
By selecting the type "POS" and entering the desired value with the corresponding
+/- keys, the feed regulator positions in the position entered. By selecting the type
"REF" and confirming the selection with the corresponding +/- keys, the feed
regulator is moved to the reference position.
DM
Adjust main drive
By selecting the type "POS" and entering the desired value with the corresponding
+/- keys, the main drive positions in the position entered.
By selecting the type "SPD" and confirming the selection with the corresponding
+/- keys, the value for the speed is changed accordingly.
By selecting the type "SC" and entering the desired value with the corresponding
+/- keys, the value for the stitch count is changed accordingly.
RES
Carry out reset
By selecting the type "PAR" and confirming the selection with the corresponding
+/- keys, the values for all parameters are reset (master reset).
By selecting the type "PRG" and confirming the selection with the corresponding
+/- keys, all seam programs are deleted.
TM
Adjust bobbin thread monitor
With the corresponding +/- key the transmitting power of the bobbin thread monitor
"Tx" can be changed.
PS
Adjust transmitted light sensors
With the corresponding +/- key the transmitting power of the transmitted light
sensors "Tx" can be changed (Lo/Hi).
VER
Display software version
Adjustment
13 - 56
Advertisement
Table of Contents
