When Using Fd-9 With Auto Sheet Feeder - Konica Minolta FD-9 Instruction Manual

Troubleshooting
9
Grasp the ends of the FD-9 and tilt the FD-9 body onto the
base again.
10
Open the cover
11
Tighten the two screws as shown until snug.
• If the screws are loose when measurements are taken, measurement accuracy may
suffer.
• Do not overtighten.
12
Close the cover.
13
Reconnect the cables and switch the FD-9 back on.

When using FD-9 with Auto Sheet Feeder

When using the FD-9 with the Auto Sheet Feeder, the location of paper jams is usually in one of the following locations: Where the paper
feeds from the supply tray into the Auto Sheet Feeder and then into the FD-9, within the FD-9, or where the paper feeds from the FD-9
through the Auto Sheet Feeder into the exit tray. To clear paper jams, check each section.
1
Switch off the FD-9.
2
Disconnect all cables (USB cable, LAN cable, AC adapter
cable).
3
Remove the FD-9 from the Auto Sheet Feeder.
• If the paper jam is inside the FD-9, follow the procedure in the preceding section
"When using FD-9 without Auto Sheet Feeder" to remove the jammed paper.
4
If paper is still jammed, lift the lever on the left side of the
supply tray and swing the supply tray mechanism out to
the right.
5
Remove any paper from inside the Auto Sheet Feeder.
28