Table of Contents
Advertisement
Unpacking
Packing Materials:
❙ ❙
Keep all packing materials (cardboard box, cushioning materials, plastic bags, etc.) in a safe place. The FD-9 is a precision measuring
instrument. In the event that the instrument needs to be shipped to a Konica Minolta authorized service facility, the packing materials can
be used to protect the instrument from impact and vibration during shipment. If the original packing materials are lost or damaged, please
contact the nearest Konica Minolta authorized service facility.
Removing Tapes:
❙ ❙
The cover, color measurement sensor unit, and conductive pads of the FD-9 have been taped in position to avoid movement during
shipment. The tapes must be removed before use.
After unpacking the FD-9 and placing it in its final location, remove the tape strips ① and ② as indicated in the illustrations below.
Open the cover and remove tape ③ as shown at right. If power is switched on before tape
③ is removed, the FD-9 may malfunction. After removing tape ③, slide the color
measurement sensor unit slightly by hand to check that it moves smoothly. If it does not
move smoothly or if there is excessive noise, please contact your local Konica Minolta
dealer.
Carefully remove the tapes ④ as shown in the figure below. Be careful not to remove the conductive pads under the tapes. If tapes ④ are
not removed, repeatability may suffer.
6
Advertisement
Table of Contents
