Troubleshooting; Error Messages; Clearing Paper Jams; When Using Fd-9 Without Auto Sheet Feeder - Konica Minolta FD-9 Instruction Manual

Troubleshooting

Error messages

❙ ❙
The messages below may be displayed when using the instrument. When one of these messages appears, please take the action indicated
below. If the message continues to appear even after taking the recommended action, contact the nearest KONICA MINOLTA authorized
service facility.
Error message Possible cause/problem
Paper jammed Paper has jammed in the FD-9.
Paper has jammed in the Auto Sheet Feeder.
Cover opened Cover of FD-9 is open.
Fatal Error A fatal error has occurred.
Error code: ********
Warning code: ********

Clearing paper jams

❙ ❙
If the paper becomes jammed during measurement, follow the procedures below to remove the jammed paper.

When using FD-9 without Auto Sheet Feeder

When using the FD-9 without the Auto Sheet Feeder, the location of paper jams is usually where the paper is fed between the base and the
scan mechanism.
1
Press to eject the paper. If the paper cannot be
ejected by the FD-9, continue with the steps below to
manually clear the paper jam.
2
Switch off the FD-9.
3
Disconnect all cables (USB cable, LAN cable, AC adapter
cable).
4
Open the cover.
5
Loosen the two screws as shown completely so that they
are free of the base.
6
Close the cover.
7
Grasp the ends of the FD-9 and tilt the FD-9 body
backward as shown. The base should stay flat.
8
Remove the jammed paper.
Action
Follow the procedure below to clear the paper jam.
Follow the procedure on p. 28 to clear the paper jam.
Close the cover and wait until FD-9 initialization is complete.
Switch off the FD-9, wait 30 seconds, and then switch it back
on. If the error continues to occur, note the Error code and
Warning code numbers, and contact the nearest KONICA
MINOLTA authorized service facility
27