Operating Homelink; Erasing The Entire Homelink Memory - Lexus LS500 Owner's Manual

the HomeLink
flashing).
■ Before programming
Install a new battery in the transmitter.
●
The battery side of the transmitter must
●
be pointed away from the HomeLink

Operating HomeLink

Press the appropriate HomeLink
button. The HomeLink
should turn on.
The status of the opening and closing
of a garage door is shown by the indi-
cators.
Opening
A
Closing
B
This function is only available if the garage
door opener motor used is a compatible
device. (To check device compatibility,
refer to www.homelink.com.)
Color
Orange (flashing)
Green
Red (flashing)
LS500h_OM_OM50F42U_(U)
5-6. Using the other interior features
®
indicator to start
®
.
®
®
®
indicator light
Status
Currently open-
ing/closing
Opening/closing has
completed
Feedback signals
cannot be received
The indicators can operate within
approximately 820 ft. (250 m) of the
garage door. However, if there are
obstructions between the garage door
and the vehicle, such as houses and
trees, feedback signals from the
garage door may not be received.
To recall the previous door operation
status, press and release either Home-
®
Link
buttons and
and simultaneously. The
last recorded status will be displayed
for 3 seconds.
Erasing the entire HomeLink
memory (all three codes)
Press and hold the 2 outside buttons
for 10 seconds until the HomeLink
indicator light changes from continu-
ously lit (orange) to rapidly flashing
(green).
If you sell your vehicle, be sure to erase the
programs stored in the HomeLink
ory.
363
or
®
5
®
®
mem-