Table of Contents
Advertisement
able, refer to P.47 for front passenger
seat adjustment.
When using the rear seat
If there is a gap between the child seat
and the seatback, adjust the seatback
angle until good contact is achieved.
2
Place the child restraint system on
the seat facing the front of the vehi-
cle.
3
Run the seat belt through the child
restraint system and insert the plate
into the buckle. Make sure that the
belt is not twisted.
4
Fully extend the shoulder belt and
allow it to retract to put it in lock
LS500h_OM_OM50F42U_(U)
1-2. Child safety
mode. In lock mode, the belt cannot
be extended.
5
While pushing the child restraint
system into the rear seat, allow the
shoulder belt to retract until the
child restraint system is securely in
place.
After the shoulder belt has retracted to a
point where there is no slack in the belt,
pull the belt to check that it cannot be
extended.
6
If the child restraint has a top tether
strap, follow the child restraint man-
ufacturer's operation manual
regarding the installation, using the
top tether strap to latch onto the
top tether strap anchor. (→P.55)
7
After installing the child restraint
system, rock it back and forth to
ensure that it is installed securely.
(→P.53)
51
1
Advertisement
Table of Contents
