Table of Contents
Advertisement
250
4-5. Using the driving support systems
Even if it is a sign not appropriate for the
●
currently traveled lane, such a sign exists
directly after a freeway branches, or in an
adjacent lane just before merging.
●
Stickers are attached to the rear of the
preceding vehicle.
A sign resembling a system compatible
●
sign is recognized.
The front of the vehicle is raised or low-
●
ered due to the carried load.
●
The surrounding brightness is not suffi-
cient or changes suddenly.
When a sign intended for trucks, etc. is
●
recognized.
●
The navigation system map data is old.
●
The navigation system is not operating.
Side road speed signs may be detected
●
and displayed (if positioned in sight of the
camera sensor) while the vehicle is trav-
eling on the main road.
●
Roundabout exit road speed signs may
be detected and displayed (if positioned
in sight of the camera sensor) while trav-
eling on a roundabout.
Speed limit sign display
■
If the power switch was last turned off while
a speed limit sign was displayed on the
multi-information display, the same sign dis-
plays again when the power switch is turned
to ON mode.
Customization
■
Some functions can be customized.
(→P.481)
LS500h_OM_OM50F42U_(U)
Dynamic radar cruise con-
trol with full-speed range
In vehicle-to-vehicle distance con-
trol mode, the vehicle automati-
cally accelerates, decelerates and
stops to match the speed changes
of the preceding vehicle even if the
accelerator pedal is not depressed.
In constant speed control mode,
the vehicle runs at a fixed speed.
Use the dynamic radar cruise con-
trol with full-speed range on free-
ways and highways.
Vehicle-to-vehicle distance con-
trol mode (→P.253)
Constant speed control mode
(→P.257)
System Components
Meter display
■
Display
A
Set speed
B
Indicators
C
Advertisement
Table of Contents
